Gigabyte GA-MA770-UD3 Manual - Page 25
SATAII0/1/2/3/4/5 SATA 3Gb/s Connectors, PWR_LED System Power LED Header - s3
UPC - 818313007216
View all Gigabyte GA-MA770-UD3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
9) SATAII0/1/2/3/4/5 (SATA 3Gb/s Connectors) The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s standard. Each SA TA connector supports a single SA TA device. The AMD SB700 controller supports RAID 0, RAID 1 and RAID 10. Refer to Chapter 5, "Configuring SA TA Hard Drive(s)," for instructions on configuring a RAID array. SATAII1 SATAII3 7 17 1 1 71 7 SATAII0 SATAII2 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND SATAII5 7 1 1 7 SATAII4 Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. 10) PWR_LED (System Power LED Header) This header can be used to connect a system power LED on the chassis to indicate system power status. The LED is on when the system is operating. The LED keeps blinking when the system is in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5). 1 - 25 - Pin No. 1 2 3 Definition MPD+ MPDMPD- System Status LED S0 On S1 Blinking S3/S4/S5 Off Hardware Installation