Gigabyte GA-P35-DS4 Manual - Page 28
GSATAII0/1 SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple, SATAII0/1/2/3/4/5 SATA 3Gb/s - raid
View all Gigabyte GA-P35-DS4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English 10) SATAII0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH9R) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The ICH9R controller supports RAID 0, RAID 1, RAID 5 and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition SATAII0 7 1 1 GND 2 TXP 3 TXN 4 GND 5 RXN 1 7 SATAII1 6 RXP 7 GND SATAII4 SATAII2 7 17 1 1 7 SATAII5 1 7 SATAII3 11) GSATAII0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition 1 GND 2 TXP 3 TXN GSATAII0 4 GND 5 RXN 6 RXP 7 GND GSATAII1 Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. GA-P35-DS4 Motherboard - 28 -