Gigabyte GA-Z270-Phoenix Gaming Users Manual - Page 7

Storage Interface USB ŠŠ ŠŠ Internal ŠŠ Connectors ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ Back Panel ŠŠ Connectors ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ ŠŠ - Support for RAID 0, RAID 1, RAID 5, and RAID 10 * Refer to "1-7 Internal Connectors," for the installation notices for the M.2 and SATA connectors. Chipset+ASMedia® USB 3.1 Gen 2 Controller: - 1 x USB Type-C™ port on the back panel, with USB 3.1 Gen 2 support - 1 x USB 3.1 Gen 2 Type-A port (red) on the back panel Chipset: - 8 x USB 3.1 Gen 1 ports (4 ports on the back panel, 4 ports available through the internal USB headers) - 4 x USB 2.0/1.1 ports (available through the internal USB headers) 1 x 24-pin ATX main power connector 1 x 8-pin ATX 12V power connector 1 x M.2 Socket 3 connector 6 x SATA 6Gb/s connectors 1 x CPU fan header 1 x water cooling CPU fan header 2 x system fan headers 1 x system fan/water cooling pump header 1 x front panel header 1 x front panel audio header 2 x USB 3.1 Gen 1 headers 2 x USB 2.0/1.1 headers 1 x RGB (RGBW) LED strip extension cable header 1 x S/PDIF Out header 1 x Trusted Platform Module (TPM) header 1 x Clear CMOS jumper 1 x PS/2 keyboard/mouse port 2 x Wi-Fi antenna connector holes 1 x DVI-D port 1 x HDMI port 1 x USB Type-C™ port, with USB 3.1 Gen 2 support 1 x USB 3.1 Gen 2 Type-A port (red) 4 x USB 3.1 Gen 1 ports 1 x RJ-45 port 1 x optical S/PDIF Out connector 5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Line In, Line Out, Mic In) I/O Controller ŠŠ iTE® I/O Controller Chip Hardware Monitor ŠŠ Voltage detection ŠŠ Temperature detection ŠŠ Fan speed detection ŠŠ Overheating warning ŠŠ Fan fail warning ŠŠ Fan speed control * Whether the fan (pump) speed control function is supported will depend on the fan (pump) you install. - 7 -