Graco 1757845 Instruction Manual - Page 20

OPERATIONS and ADJUSTMENTS 1 Harness Straps (fig. a): • To tighten: Pull lower belt. • To loosen: Pull and hold upper belt tab while pulling shoulder harness straps. 2 Harness Tie: • To open: Press tabs and pull apart. • To close: Snap halves together. Make sure harness tie is locked by pulling out on each half. 3 Buckle: MUST be in opening closest to but not under child. 5-Point Models • To buckle: Insert both tongues into buckle. Pull up on tongues to be sure they are locked. • To unbuckle: Press red button and pull tongues out of buckle. Overhead Shield Models • To buckle: Push tongue into opening. Pull up on tongue to be sure it is locked. • To unbuckle: Press red button, pull tongue out of opening and lift shield 18 over top of child restraint. 4 Recline / Upright Positions (fig. b): Rear-facing - MUST use Recline position. Forward-facing - MUST use Upright position Upright Position: Rotate stand out and push into child restraint (fig. b). Secure recline stand by pushing tabs into lock position. Recline Position: Pull stand out and rotate into child restraint. Harness straps MUST move freely. Make sure harness straps are not pinched by recline stand. 5 5-Point Crotch Strap Adjustment (fig. c): • From bottom of child restraint, pull crotch strap clip out and remove clip from crotch strap loop. • From top of child restraint, pull crotch strap out and thread through desired slot. Make sure red button is facing away from child. • From bottom of child restraint, re-attach clip to crotch strap loop exactly as shown. 6 Overhead Shield Adjustment (fig. d): • To adjust: Press button down and slide shield to desired position closest to child. Release button to lock shield into one of multiple positions. NOTE: Shield does not need to contact child when in closest position; harness system restrains child.