Haier 21T9B-S User Manual - Page 6

POWER SUPPLY 1.Power supply (switch on/off to set main power supply). Press power switch button and the TV set shall be under normal receiving condition. Press it again and the power shall be off. 2.Standby button (remote control power supply). Press the button and the TV set enters standby condition, press it again and the set enters normal receiving condition. TUNING PROCEDURE 1.Preparation Connect the aerial and power supply wire, press power switch button, the power indicator will light after a few seconds. 2.Auto-search The TV set will automatically search all TUNING POSITION 1 BAND UHF SKIP OFF SEARCH UP MFT DOWN AUTO MEMORY SELECT ADJUST programs, after the search is finished, all fine tuned programs will be stored automatically. (1)Press [MENU] button to let TUNING menu display on the screen. (2)Press [-CH+] button to select AUTO MEMORY item. (3)Press [VOL+] button, the TV set will begin to search programs from program number 0. After the search is finished, program number 0 will display on the screen. (4)During auto-search, if you want to stop searching, press [VOL-] button. 3.Semi-Auto search You can preset the program you need to the pointed channel. 7 TUNING PROCEDURE (1)Press [MENU] button to let TUNING menu display on the screen. (2)Press [-CH+] buttons to select SEARCH item. (3)Press [-VOL+] buttons to change channel number into pointed channel number. (4)Press [-VOL+] buttons, when the TV set has searched a program, stop searching, if the program isn't the one you need, press[-VOL +] buttons again, the set will search continually until it has searched the program you need. And pointed program is stored in pointed channel. 4.Selecting band In the semi-auto search mode, if the signal you want to search isn't on the present band, you can change the band to improve searching speed. (1)Press [MENU] button to let TUNING menu display on the screen. (2)Press [-CH+] buttons to select BAND item. (3)Press [-VOL+] buttons to select the band you need. VHFL VHFH UHF 5.Fine tuning Because of some reasons, if auto searching effect of program isn't good, please fine tune your TV set. (1)Press [-CH+] buttons, and select MFT item. (2)Press and hold [-VOL +] buttons until the effects of the picture and audio are good. 6.Skip The function can skip the TV program which you don't need. (1)Press [-CH+] button or numeric button to select the program number which you want to skip. (for example: channel 002) (2)Press [MENU] button to select TUNING menu. (3)Press [-CH+] buttons to select SKIP item. (4)Press [-VOL+] buttons to preset SKIP ON mode. Note: When a certain program number is in SKIP ON mode, the program number will not appear when you select program with the [-CH+] buttons, but program number will appear with numeric button. When a certain program number is in the SKIP OFF mode, the program number will appear when you select program with [-CH+] buttons. 8