Haier HR-176A User Manual - Page 13

This User's Manual is applicable to a variety of models and there may be slight changes in certain aspects from model to model. 1. Environmental Protection and Proper Disposal Package materials The appliance is packaged in a way to prevent damages during transportation. Recyclable materials are used. The packing box is made of corrugated board / cardboard (mainly from recycled paper). y Polystyrene parts (CFC-free foamed polystyrene) y Linings and polyethylene bags y Polypropylene straps All these valuable materials may be taken to a waste collecting center and used again after adequate recycling. All waste materials should be disposed properly. 2. Location Make sure the refrigerator is kept upright during handling. If an inclination is required, it should not exceed 45 degrees. Otherwise the appliance may get damaged resulting not only in compromised refrigeration performance. To avoid product damage or personal injury, the refrigerator should be unpacked by two persons after it is located in a previously selected position. Before installation, make sure the refrigerator has no visible exterior damage. When handling the refrigerator, do not lift it by holding the worktop, to prevent any damage to the refrigerator. Do not start up a refrigerator that is damaged. Check the refrigerator carefully for: y Damaged package due to inappropriate handling during transportation y Damage in the exterior y Damage in power cord / plug Any doubt, please contact Customer Service for a thorough checkup of the appliance. Take necessary measures to prevent leakage of refrigerant at the start-up of refrigerator that may result in environmental pollution. 3. Installation a) Remove all package materials. b) Remove items in the refrigerator. c) Make sure to remove film and tape on the cabinet and the door. d) Remove polystyrene chips (if any) around the refrigerator. e) Take out accessories and literature in the refrigerator. f) Clean the inside of the refrigerator with lukewarm water and vinegar and then dry it with a soft cloth. g) Use the spanners supplied to adjust the leveling leg to ensure the refrigerator is stable. Do not use detergents, sharp or pointed instruments or soda-based cleansers to clean the refrigerator. y Before installation, make sure the refrigeration system is free of any damage. y The refrigerator should be used for its intended purpose only. y The refrigerator should be positioned on the solid and even floor to ensure refrigerant circulation and refrigerating performance. y If possible, position the refrigerator in a cool and dry well ventilated room. y Do not expose the refrigerator to direct sunshine and make sure the ambient temperature is not extremely high. y Keep the refrigerator from a heat source, such as heating system, oven or cookers. Otherwise the compressor will operate more frequently resulting in extra power consumption. If the refrigerator will be placed near a heat source, it is recommended to install a thermal barrier between the refrigerator and the heat source (asbestos is prohibited) or maintain adequate space between the refrigerator and the heat source as follows: Cooker or electric stove Radiator or oven Another refrigerator 3 cm 30 cm 2 cm Do not place any radiating apparatus, such as microwave oven or roaster, on top of the refrigerator. Make sure the air vent is not obstructed. Never unplug the refrigerator by pulling on the power cord. Always grip the plug firmly and pull it straight out from the outlet. 2