Harman Kardon AVR 120 Owners Manual - Page 15

Installation and Connections 2. Connect the analog audio and video outputs of a satellite receiver, cable TV converter or television set or any other video source to the Video 2 or Video 3 Jacks bcfg. 3. Connect the analog audio and video outputs of a DVD or laser disc player to the DVD Jacks §⁄. When a digital audio connection is used for your DVD player, the default connection is the Coaxial Digital Input 1 Jack e. However, the connection may also be made to any of the Optical d# or Coaxial e$ Digital Inputs, provided that the digital input source selection is changed as shown on page 23. 4. Connect the digital audio outputs of a DVD player, satellite receiver, cable box or HDTV converter to the appropriate Optical or Coaxial Digital Inputs de#$. 5. Connect the Video Monitor Output ¤ jacks on the receiver to the composite or S-Video input of your television monitor or video projector. Video Connection Note: • Composite and S-Video signals may only be viewed in their native formats. Power Connections This unit is equipped with two accessory AC outlets. They may be used to power accessory devices, but they should not be used with highcurrent draw equipment such as power amplifiers. The total power draw to each outlet may not exceed 100 watts. The Switched AC Accessory Outlet fl will receive power only when the unit is on. This is recommended for devices that have no power switch or a mechanical power switch that may be left in the "ON" position. NOTE: Many audio and video products go into a Standby mode when they are used with switched outlets, and cannot be fully turned on using the outlet alone without a remote control command. The Unswitched AC Accessory Outlet ‡ will receive power as long as the unit is plugged into a powered AC outlet. Finally, when all connections are complete, plug the Power Cord ° into a nonswitched 120-volt AC wall outlet. You're almost ready to enjoy the AVR 120! 15 INSTALLATION AND CONNECTIONS