Harman Kardon AVR 335 Owners Manual - Page 40

Example:

To use the Video 4 button to operate

a satellite receiver, first press the

Video 4 Input

Selector

e

and the

Mute Button

at the

same time until the red light glows under the

Video

4 Button

e

. Press the

VID2/SAT Button

e

,

followed by the three-digit code for the specific

model you wish to control. Finally, press the

Video 4 Button

e

again.

Resetting the Remote Memory

As you add components to your home theater system,

occasionally you may wish to totally reprogram the

remote control without the confusion of any commands,

macros or “Punch-Through” programming that you may

have done.To do this, it is possible to reset the remote

to the original factory defaults and command codes by

following these steps. However, once the remote is

reset, all commands or codes that you have entered will

be erased and will need to be reentered:

1. Press any of the

Input Selector Buttons

e

and

the

“O” Button

r

at the same time until the

Program Indicator

c

begins to flash amber.

2. Press the

“3” Button

r

three times.

3. The red LED under the

Input Selector

e

will go

out and the

Program Indicator

c

will stop flash-

ing and turn green.

4. The

Program Indicator

c

will remain green until

the remote is reset. Note that this may take a while,

depending on how many commands are in the

memory that need to be erased.

5. When the

Program Indicator

c

goes out, the

remote has been reset to the factory settings.

41

40

PROGRAMMING THE REMOTE

PROGRAMMING THE REMOTE

Harman Kardon AVR 335 Owners Manual - Page 40

Resetting the Remote Memory

Page 40 highlights