HP 1606 Access Gateway Administrator's Guide (53-1001760-01, June 2010) - Page 29
Port state description, command to disable the switch. - laser
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Enabling and disabling Access Gateway mode 2 When you disable AG mode, The switch automatically reboots and comes back online using the fabric switch configuration; the AG parameters, such as port mapping, and Failover and Failback are automatically removed. When the switch reboots, it starts in Fabric OS Native mode. To re-join the switch to the core fabric, refer to "Rejoining Fabric OS switches to a fabric" on page 67. 9. Enter the switchDisable command to disable the switch. switch:admin> switchdisable 10. Enter the ag command with the --modedisable operand to disable AG mode. switch:admin> ag --modedisable 11. Enter the ag --modeshow command to verify that AG mode is disabled. switch:admin> ag --modeshow Access Gateway mode is NOT enabled Port state description The following table describes the possible port states. TABLE 3 Port state description State Description No _Card No _Module Mod_Val Mod_Inv No_Light No_Sync In_Sync Laser_Flt Port_Flt Diag_Flt Lock_Ref Testing Offline Online No interface card present No module (GBIC or other) present Module validation in process Invalid module The module is not receiving light Receiving light but out of sync Receiving light and in sync Module is signaling a laser fault Port marked faulty Port failed diagnostics Locking to the reference signal Running diagnostics Connection not established (only for virtual ports) The port is up and running Access Gateway Administrator's Guide 9 53-1001760-01