HP 1606 Fabric OS Administrator's Guide v6.4.0 (53-1001763-01, June 2010) - Page 213

Management interface security 7 -t SELECTOR-IN -d in -l 10.33.69.132 -r 10.33.74.13 \ -transform TRANSFORM01 10. Verify the IPsec SAs created with IKE using the ipsecConfig --show manual-sa -a command. 11. Perform the equivalent steps on the remote peer to complete the IPsec configuration. Refer to your server administration guide for instructions. 12. Generate IP traffic and verify that it is protected using defined policies. a. Initiate Telnet or SSH or ping session from BRCD300 to Remote Host. b. Verify that the IP traffic is encapsulated. c. Monitor IPsec SAs created using IKE for the above traffic flow. • Use the ipSecConfig --show manual-sa -a command with the operands specified to display the outbound and inbound SAs in the kernel SADB. • Use the ipSecConfig --show policy ips sa -a command with the specified operands to display all IPsec SA policies. • Use the ipSecConfig --show policy ips sa-proposal -a command with the specified operands to display IPsec proposals. • Use the ipSecConfig --show policy ips transform -a command with the specified operands to display IPsec transforms. • Use the ipSecConfig --show policy ips selector -a command with the specified operands to display IPsec traffic selectors. • Use the ipSecConfig --show policy ike -a command with the specified operands to display IKE policies. • Use the ipSecConfig --flush manual-sa command with the specified operands to flush the created SAs in the kernel SADB. CAUTION Flushing SAs requires IPsec to be disabled and re-enabled. This operation is disruptive to traffic on the tunnel. Fabric OS Administrator's Guide 173 53-1001763-01