HP 1606 Fabric OS Administrator's Guide v6.4.0 (53-1001763-01, June 2010) - Page 479

F_Port masterless trunking 19 Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%) Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%) 38->1 sp: 8.000G bw: 8.000G deskew 15 Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%) Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%) Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%) 37->1 sp: 8.000G bw: 8.000G deskew 15 Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%) Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%) Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%) 36->1 sp: 8.000G bw: 8.000G deskew 15 Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%) Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%) Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%) Enabling the DCC policy on a Trunk Area After you assign a Trunk Area, the portTrunkArea CLI checks whether there are any active DCC policies on the port with the index TA, and then issues a warning to add all the device WWNs to the existing DCC policy with index as TA. All DCC policies that refer to an Index that no longer exists will not be in effect. 1. Add the WWN of all the devices to the DCC policy against the TA. 2. Enter the secPolicyActivate command to activate the DCC policy. You must enable the TA before issuing the secPolicyActivate command in order for security to enforce the DCC policy on the trunk ports. 3. Turn on the trunk ports. Trunk ports should be turned on after issuing the secPolicyActivate command to prevent the ports from becoming disabled in the case where there is a DCC security policy violation. You can configure authentication on all three Brocade trunking configurations. For more information on authentication, see Chapter 7, "Configuring Security Policies". Fabric OS Administrator's Guide 439 53-1001763-01