HP 1606 Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010) - Page 733
ZONE System Messages, ZONE-1002
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 733 highlights
ZONE System Messages Chapter 111 ZONE-1002 Message , [ZONE-1002], ,, WARNING, , WWN zoneTypeCheck or zoneGroupCheck warning() at port(). Probable Cause Indicates a zone filter or zone group check failure occurred. The frame filter logic reported a failure when creating or adding zone groups during port login (PLOGI) trap processing. This messages usually indicates problems when adding content-addressable memory (CAM) entries before the filter setup. Recommended If the message persists, run the supportFtp command (as needed) to set up automatic FTP Action transfers; then run the supportSave command and contact your switch service provider. Severity WARNING ZONE-1003 Message , [ZONE-1003], ,, WARNING, , zone() contains (, ) which does not exist. Probable Cause Indicates the port zone member that is targeted for the local switch contains a non-existent port. The effective zoning configuration (displayed in the error message) contains a port number that is out of range. Recommended Edit the zone database and change the port number to a viable value in the effective configuration. Action Severity WARNING ZONE-1004 Message Probable Cause , [ZONE-1004], ,, INFO, , port () enforcement changed to Session Based HARD Zoning. Indicates the zoning enforcement has changed to session-based hard zoning. When a device is zoned using both World-Wide Name (WWN) in one zone and in another, this will cause the port to go to session-based hard zoning. Fabric OS Message Reference 657 53-1001767-01