HP 1606 Fabric OS MIB Reference v6.4.0 (53-1001768-01, June 2010) - Page 35

Fabric OS commands for configuring SNMP 1 Fabric OS commands for configuring SNMP Use the following commands (Table 4) to configure MIBs in the Fabric OS. Refer to the Fabric OS Administrator's Guide for procedures for configuring SNMP on the Brocade switches. TABLE 4 Commands for configuring SNMP Command Description snmpConfig snmpMibCapSet snmpMibCapShow snmpTraps This command has all the features of the existing agtcfg* commands; in addition, it has SNMPv3 configuration parameters. Enhanced in Fabric OS v6.3.0 to support SNMP Informs for SNMPv3 users. Enhanced in Fabric OS v6.4.0 to support option based mibcapability behavior. Obsoleted command. Use snmpConfig command. Obsoleted command. Use snmpConfig command. To support SNMP notification generator feature, Notification generator framework has been implemented to send various SNMP traps. TABLE 5 Command For more information about the commands, refer to Table 5. Detailed description of the commands Operands Arguments snmpConfig --show | --set | --default show [snmpv1 | snmpv3 | accessControl | Displays the SNMP agent configuration data of mibCapability |systemGroup |seclevel] the specified category. set Sets the SNMP agent configuration data of the specified category. This operand displays the current settings and then prompts you to change the values for each parameter. default Sets the SNMP agent configuration data for a specified item to the default values. Generally, these default values may be available in the configuration database. The command sets to factory defaults if the SNMP agent configuration parameters are not available in the configuration database. snmpv1 Selects SNMPv1-related configuration parameters. These parameters include the community string, trap recipient IP address, and trap severity level associated with each trap recipient IP address. When "0" is configured as a trap port, traps can be received at the default port 162. snmpv3 Selects SNMPv3-related configuration parameters. These parameters include the user name, authentication protocol and password, the privacy protocol and password, the SNMPv3 trap recipient's IP address, its associated user index and trap severity level. When "0" is configured as a trap port, traps can be received at the default port 162. In Fabric OS 6.3.0 and later, the --set snmpv3 command supports an interactive option to enable or disable informs by setting the parameter "SNMP Informs Enabled" to true or false. If informs are enabled, all trap destinations receive inform requests. If informs are disabled, all trap destinations receive trap requests. When informs are enabled, the engine ID must be set to correspond to the management engine IP address (see example). Informs are by default disabled. IPv6 Informs are currently not supported. accessControl Selects access-control-related parameters. These parameters include the access host subnet area and access permission (read-write). Fabric OS MIB Reference 17 53-1001768-01