HP 2000fc HP StorageWorks 2000 Modular Smart Array Controller Module Replaceme - Page 1
HP 2000fc Manual
View all HP 2000fc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP StorageWorks 2000 Modular Smart Array Controller Module Replacement Instructions About this document • Illustrations in this document may show a controller module with a connection interface that differs from your controller module. Replacement procedures are the same for all MSA2000 controller modules. • The Storage Management Utility (SMU) and the Command Line Interface (CLI) can be used to manage MSA2000-family enclosures. Tasks in this document demonstrate using the SMU. • For the latest product documentation, see the HP website at http:// www.hp.com/support/manuals. Under the storage banner, navigate to the page for your storage enclosure. This document details procedures for replacing a failed controller module in an HP StorageWorks 2012/2212 Modular Smart Array (MSA2000). © Copyright 2008, 2010 Hewlett-Packard Development Company, L.P. Third edition: March 2010 The information in this document is subject to change without notice. Printed in China. www.hp.com Before you begin Observe the following: CAUTION: • When replacing a controller in an operational controller en- closure, ensure that less than 10 seconds elapse between inserting the controller into a slot and fully latching it in place. Failing to do so might cause the controller to fail. If it is not latched within 10 seconds, remove the controller from the slot and repeat the process. • Removing a module from an operational enclosure significantly changes air flow within the enclosure. Openings must be populated for the enclosure to cool properly. Leave modules in the enclosure until a replacement is available. • Parts can be damaged by electrostatic discharge; use proper anti-static protection. Keep parts in electrostatic containers until needed and ensure you are properly grounded when touching static-sensitive components. IMPORTANT: When replacing both controllers in an operational enclosure, do as follows: 1. Replace one controller as detailed in these instructions. 2. Wait 30 minutes. This pause ensures that the two controllers and their ownership of the vdisks have enough time to fully stabilize. 3. Examine system status and event logs to ensure that the system is stable. 4. Replace the other controller as detailed in these instructions. *488318-003* IMPORTANT: When two controllers are installed in an enclosure, they must be the same model. Mixing controller types in the same enclosure is not supported. Page 1