HP 3PAR StoreServ 7200 2-node HP 3PAR StoreServ 7000/7450 Storage Cabling Conf - Page 19

Node Interconnect Cabling, Controller A, Node 0, Intr 1 to Controller C, Intr 0

Get HP 3PAR StoreServ 7200 2-node PDF manuals and user guides View all HP 3PAR StoreServ 7200 2-node manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

4 Node Interconnect Cabling The interconnection between Controller A (node pair 0/1), and Controller B (node pair 2/3) uses the four large interconnect cables. The cables are DIRECTIONAL and must be installed correctly for the system to function properly. Connect one cable at a time: 1. Controller A, Node 0, Intr 0 to Controller C, Node 2, Intr 1 2. Controller A, Node 0, Intr 1 to Controller C, Node 3, Intr 0 3. Controller A, Node 1, Intr 0 to Controller C, Node 3, Intr 1 4. Controller A, Node 1, Intr 1 to Controller C, Node 2, Intr 0 The completed cabling is shown below. After confirming that all cabling is correct (SAS and interconnection), the system may be powered on by using procedures from the installation guide. CAUTION: The Interconnect Link Cables are directional. Watch for labels A and C. 4 Node 6 Drive Enclosures (6S) 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
4 Node Interconnect Cabling
The interconnection between Controller A (node pair 0/1), and Controller B (node pair 2/3) uses
the four large interconnect cables.
The cables are DIRECTIONAL
and must be installed correctly for the system to function properly.
Connect one cable at a time:
1.
Controller A, Node 0, Intr 0 to Controller C, Node 2, Intr 1
2.
Controller A, Node 0, Intr 1 to Controller C, Node 3, Intr 0
3.
Controller A, Node 1, Intr 0 to Controller C, Node 3, Intr 1
4.
Controller A, Node 1, Intr 1 to Controller C, Node 2, Intr 0
The completed cabling is shown below.
After confirming that all cabling is correct (SAS and interconnection), the system may be powered
on by using procedures from the installation guide.
CAUTION:
The Interconnect Link Cables are directional. Watch for labels
A
and
C
.
4 Node 6 Drive Enclosures (6S)
19