HP 3PAR StoreServ 7400 2-node HP 3PAR StoreServ 7000/7450 Storage Cabling Conf - Page 196
HP 3PAR StoreServ 7400 2-node Manual
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
4 Node Interconnect Cabling The interconnection between Controller A (node pair 0/1), and Controller B (node pair 2/3) uses the four large interconnect cables. The cables are DIRECTIONAL and must be installed correctly for the system to function properly. Connect one cable at a time: 1. Controller A, Node 0, Intr 0 to Controller C, Node 2, Intr 1 2. Controller A, Node 0, Intr 1 to Controller C, Node 3, Intr 0 3. Controller A, Node 1, Intr 0 to Controller C, Node 3, Intr 1 4. Controller A, Node 1, Intr 1 to Controller C, Node 2, Intr 0 The completed cabling is shown below. After confirming all cabling is correct (SAS and interconnection), the system may be powered on by using procedures from the installation guide. CAUTION: The Interconnect Cables are directional and labeled A and C. 196 Cabling HP 3PAR StoreServ 7000/7450