HP 3PAR StoreServ 7450 2-node HP 3PAR StoreServ 7450 Storage Site Planning Man - Page 38
Table 20 SP and Storage System Software Installation Checklist, continued
View all HP 3PAR StoreServ 7450 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Table 20 SP and Storage System Software Installation Checklist (continued) Custom duplex (half or full) and Custom speed (10, 100, or 1000 MB/s) Proxy server settings for Remote Support (if applicable): Protocol Address and port Authentication information (optional) Date and time: Enter manually Use NTP server information Time zone region New password to assign setupusr (for use with the system setup wizards) NOTE: All passwords for the setupusr username must be between 7 and 32 characters in length and can consist of alphanumeric characters and the following special characters: period (.), plus (+), dash (-), equal (=), and forward slash (/). New password to assign 3parcust (to access SPOCC) NOTE: All passwords for the 3parcust username must be between 7 and 32 characters in length and can consist of alphanumeric characters and the following special characters: period (.), plus (+), dash (-), equal (=), and forward slash (/). HP 3PAR Storage System Serial number NOTE: The serial number is located on the back of your HP 3PAR storage system next to the power switch for the node enclosure PCM. It begins with 16 (for example, 1624635). StoreServ system name IP address (IPv4 only) Subnet mask Gateway IP address If applicable, • Domain Name • DNS Server Enable remote support: • Protocol • Address • Port Customer contact: • Installation site information • Customer information Date and time: Copy from SP Enter manually Use NTP server information Time zone region 38 Storage System Installation Checklist