HP 420 Compaq 320, 321, 420, 421, 620 and 621 Notebook PCs HP 420 and 620 Not - Page 105
the extender to the base enclosure., Remove the system board on
View all HP 420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Remove the system board on a 39.6-cm (15.6-in) computer: 1. Position the computer with the front toward you. 2. Release the audio ZIF connector (1) and disconnect the cable (2) from the left edge of the system board. 3. Remove the two Phillips M2.0×3.0 screws (3) that secure the system board to the base enclosure. 4. Remove the optical drive extender by first removing the Phillips PM2.0×3.0 screw (1) that secures the extender to the base enclosure. 5. Lift the system board slightly and then pull the extender straight out (2) from the system board. 6. Remove the hard drive extender by first removing the Phillips PM2.0×3.0 screw (1) that secures the extender to the base enclosure. Component replacement procedures 97
Remove the system board on a
39.6-cm
(15.6-in) computer:
1.
Position the computer with the front toward you.
2.
Release the audio ZIF connector
(1)
and disconnect the cable
(2)
from the left edge of the system
board.
3.
Remove the two Phillips M2.0×3.0 screws
(3)
that secure the system board to the base enclosure.
4.
Remove the optical drive extender by first removing the Phillips PM2.0×3.0 screw
(1)
that secures
the extender to the base enclosure.
5.
Lift the system board slightly and then pull the extender straight out
(2)
from the system board.
6.
Remove the hard drive extender by first removing the Phillips PM2.0×3.0 screw
(1)
that secures
the extender to the base enclosure.
Component replacement procedures
97