HP 420 Compaq 320, 321, 420, 421, 620 and 621 Notebook PCs HP 420 and 620 Not - Page 78
Remove the two Torx M2.5×6.0 screws, 3-in computers
View all HP 420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
4. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect the cable (2) from the system board. 5. Remove the palm rest. Remove the palm rest on 35.6-cm (14-in) or 33.8-cm (13.3-in) computers: 1. Position the computer upside down with the front toward you. 2. Remove the two Torx M2.5×6.0 screws (1) and one Philllips PM2.25×2.5 broadhead screw (2) that secure the palm rest to the computer. 70 Chapter 4 Removal and replacement procedures
4.
Release the ZIF connector
(1)
to which the TouchPad cable is connected, and then disconnect the
cable
(2)
from the system board.
5.
Remove the palm rest.
Remove the palm rest on
35.6-cm
(14-in) or
33.8-cm
(13.3-in) computers:
1.
Position the computer upside down with the front toward you.
2.
Remove the two Torx M2.5×6.0 screws
(1)
and one Philllips PM2.25×2.5 broadhead screw
(2)
that secure the palm rest to the computer.
70
Chapter 4
Removal and replacement procedures