HP 600N HP JetDirect Print Servers 600N/400N/500X/300X Administrator's Guide - - Page 126
Table 7.5, General HP JetDirect Messages 6 of 15, LAN ERROR-LOSS - jetdirect jumper settings
UPC - 088698541357
View all HP 600N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Table 7.5 General HP JetDirect Messages (6 of 15) Message Description LAN ERROR-JUMPER The data rate switch on the HP JetDirect print server is set incorrectly. For instructions on setting the data rate switch, see the hardware installation guide for your print server. LAN ERROR-LOSS OF CARRIER Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP JetDirect print server. For replacement instructions, see the hardware installation guide for your print server. LAN ERROR-NO LINKBEAT With a 10/100 Base-T port connected, this message is displayed if Link Beat is not sensed. Check the network cable, and verify that the concentrator/hub is providing Link Beat. LAN ERROR-NO SQE Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP JetDirect print server. For replacement instructions, see the hardware installation guide for your print server. LAN ERROR-OPEN The HP JetDirect print server could not insert into the ring and join the network. Check the data rate switch on the HP JetDirect print server to make sure it is set correctly. For information on setting the data rate switch, see the HP JetDirect internal print server hardware installation guides. In addition, check the cabling, external transceiver, wiring concentrator, and taps. LAN ERROR-RECEIVER OFF There may be a problem with your network cabling or the HP JetDirect print server. Check the cabling and BNC "T" connectors on your Ethernet network. If you cannot find a problem with your network cabling, run the power-on self-test: turn the printer off, then on again. If the error persists after the printer is turned on again, there is a problem with the HP JetDirect print server. LAN ERROR-REMOVE RECEIVE Run the power-on self-test: turn the printer off, then on again. If this message reappears on the resulting configuration page, you may have a problem with one of the HP JetDirect print servers on your network. Check all the HP JetDirect print servers on the network for proper operation. LAN ERROR-RETRY FAULTS There is a problem with your network cabling or external network configuration. Make sure that your network cable is correctly terminated at both ends. Verify operation of the hub or switch port. 120 HP JetDirect Configuration Page Messages EN