HP 620n HP Jetdirect Administrator's Guide - Page 115

Table 4.3 Item 802.11 Configuration Parameters (4 of 4) Description TCP/IP settings To minimize reconnections to the print server for initial network configuration, the 802.11 page allows you to configure the following basic TCP/IP settings at the same time that you configure your wireless connection settings: ● IP Configuration Method ● IP address ● Subnet Mask ● Default Gateway For a description of these parameters, see TCP/IP below. TCP/IP The TCP/IP page provides configuration parameters summarized in Table 4.4. Table 4.4 Item TCP/IP Settings (1 of 3) Description IP Configuration Method Selects the method that the HP Jetdirect print server will use for its IP configuration parameters: BOOTP (default), DHCP, Manual, or Auto IP. For BOOTP or DHCP, the IP parameters will be automatically configured by a BOOTP or DHCP server each time the print server is powered on. If you select Manual, then basic IP parameters can be manually entered using this Web page, or using other available tools. If you select Auto IP, then a unique link-local address 169.254.x.x will be assigned. For more information, see Chapter 3. Host Name Specifies a readable IP name (the SNMP SysName object) for the network device. The name must start with a letter and can end in a letter or number, up to 32 ASCII characters. The default name is NPIxxxxxx, where xxxxxx is the last six digits of the LAN hardware (MAC) address. IP Address Use this field to manually assign the Internet Protocol address on the HP Jetdirect print server. The IP address is a four byte (32-bit) address in the form "n.n.n.n", where 'n' is a number from 0 to 255. An IP address uniquely identifies a node on a TCP/IP network. Duplicate IP addresses on a TCP/IP network are not allowed. For more information on IP addresses, see Appendix A. ENWW Using the Embedded Web Server 115