HP 6400/8400 HP StorageWorks disk enclosure front UID replacement instructions
HP 6400/8400 Manual
 |
View all HP 6400/8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 6400/8400 manual content summary:
- HP 6400/8400 | HP StorageWorks disk enclosure front UID replacement instructions - Page 1
enclosure front UID replacement instructions About this document For the latest documentation, go to http://www.hp.com/support/manuals and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in - HP 6400/8400 | HP StorageWorks disk enclosure front UID replacement instructions - Page 2
• = Unit identification. Push switch to illuminate solid blue; push again to turn off. The UID mimics the status of the UID at the rear of the enclosure. Removing the front UID board 1. Power down the enclosure. a. For the MSA6X/7X: Power down any attached servers (see your server documentation
-
1 -
2
 |
 |
HP StorageWorks
disk enclosure front UID
replacement instructions
These instructions apply to the MSA6X/7X, Proliant
DL320S, EVA4400, EVA6400, and EVA8400 product
families.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
Second edition: February 2009
The information in this document is subject to change without notice.
Printed in Puerto Rico
www.hp.com
*533477-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/man
uals
and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
h
t
tp://w
w
w
.hp
.co
m/
go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
See
Figure 1
for the location of the front UID board on the front of the
disk enclosure.
gl0109
1
1. Front UID under plastic bezel
Figure 1 Location of the front UID board
Verifying component failure
Improper or failed operation of the LEDs on the front UID may indicate
a replacement is necessary.
Proper LED operation for the MSA6X/7X is displayed as:
•
Blue
= Identified
•
Blue flashing
= Active remote management
•
Off
= No active remote management
Proper LED operation for the EVA is displayed as:
•
= Enclosure external health. Solid green indicates the enclosure
is operating normally. Blinking green indicates power up.
•
= Enclosure fault warning. Flashing amber indicates a fault of
lesser importance, while solid amber indicates a fault of greater im-
portance.
Page 1