HP 8/24 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, July 2009) - Page 156
TABLE 5, Zoning Operation Parameters, RSCN Transmission Mode, Arbitrated Loop Parameters
View all HP 8/24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
2 configure Note that the maximum logins per port parameter can be configured only for external ports. Zoning Operation Parameters Table 5 lists the configurable zoning operation parameters. TABLE 5 Zoning operation parameters Field Type Default Range Disable NodeName Zone Boolean 0 1 Checking Disable NodeName Zone Checking Specify 1 to disable using node WWN when specifying nodes in the zone database, or specify 0 to enable using node WWN when specifying nodes in the zone data. The default value is 0. This value must be set to 1 for interpretability. RSCN Transmission Mode Table 6 lists the RSCN transmission mode values fields. TABLE 6 RSCN transmission modes Field End-device RSCN Transmission Mode Domain RSCN to End-device for switch IP address or name change Type number number Default 1 0 Range 0 to 2 0 to 1 End-device RSCN Transmission Mode values are as follows: 0 RSCN only contains single PID 1 RSCN contains multiple PIDs 2 Fabric addresses RSCN Domain RSCN to End-device for switch IP address or name change values are as follows: 0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change. 1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change. Arbitrated Loop Parameters The Arbitrated Loop Setting fields are described in Table 7. TABLE 7 Configure command arbitrated loop settings Field Default Send FAN frames? 1 Enable CLOSE on OPEN received? 4 Always send RSCN? 0 Range 0 or 1 0 to 4 0 or 1 126 Fabric OS Command Reference 53-1001337-01