HP 8/8 Access Gateway Administrator's Guide (53-1001760-01, June 2010) - Page 43
Device mapping considerations, Access Gateway configuration.
View all HP 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Access Gateway mapping 2 1. Static device mapping to N_Port (if defined) 2. Device mapping to N_Port group (if defined) For more information, refer to "Port Grouping policy" on page 33. 3. Automatic WWN load balancing within a port group (if enabled) For more information, refer to "Port Grouping policy" on page 33. NOTE Only NPIV devices can use device mapping and the automatic WWN Load Balancing policy. NOTE In Fabric OS v6.4.0, the device load balancing policy is enabled per module rather than per port group. 4. Port mapping to an N_Port 5. Port mapping to an N_Port in a port group (if defined) For more information, refer to "Port Grouping policy" on page 33. Device mapping considerations Consider the following points when using device mapping: • If the N_Port is disabled, all devices that are mapped to it will be disabled. Depending on the effective failover policy, the devices will be enabled on other N_Ports. • Similar to Port-based mappings, device-based mappings are affected by changes to underlying F_Ports. In other words, if an F_Port needs to be taken offline, both the physical device and all virtual nodes behind it will momentarily go offline. • Once devices are mapped to an N_Port rather than an N_Port group, they cannot be automatically rebalanced to another N_Port if an additional N_Port comes online. • There can be cases where two NPIV devices logging through the same F_Port are mapped to two different N_Ports that are connected to two different fabrics. In this case, both NPIV devices may be allocated the same PID by their respective fabric. Once Access Gateway detects this condition, it will disable that F_Port, and the event will be logged. NOTE Access Gateway algorithms reduce the chances of PID collisions, but they cannot be totally eliminated. In some cases, you may be able to configure your virtual or physical fabrics to further reduce this condition. • Device mapping is not supported when firmware is downgraded to Fabric OS 6.3.x or lower. You must delete device mappings before downgrading or disable Device Load Balancing. • Static and dynamic device mapping are only supported on the edge module in a cascaded Access Gateway configuration. • When mapping devices to a port group, make sure that all ports in the group have the same NPIV login limit. If some ports have a lower login limit than the other ports, and there are many logins to the group, some devices will repeatedly attempt to connect to the device with the lower limit (because it has the fewest logins) and fail to connect. Access Gateway Administrator's Guide 23 53-1001760-01