HP 8/8 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, Ju - Page 224
qos trust cos, To set the interface QoS to the trust mode
View all HP 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
12 qos trust cos DRAFT: BROCADE CONFIDENTIAL qos trust cos Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples See Also Specifies the interface QoS trust mode for incoming traffic. qos trust cos no qos trust none The QoS trust CoS mode set to the untrusted state. Interface configuration mode Use this command to specify the interface ingress QoS trust mode, which controls user priority mapping of incoming traffic. The untrusted mode overrides all incoming priority markings with the Interface Default CoS. The CoS mode sets the user priority based on the incoming CoS value, if the incoming packet is not priority tagged, then fallback is to the Interface Default CoS value. Use the no qos trust command to return to the default. When a CEE map is applied on an interface, the qos trust command is not allowed. The CEE map always puts the interface in the CoS trust mode. This command is not applicable for port-channel interfaces. To set the interface QoS to the trust mode: switch(conf-if-te-0/1)#qos trust cos To return the interface QoS to the default value or to the untrusted state: switch(conf-if-te-0/1)#no qos trust When a CEE map is applied, the switch does not allow the qos trust cos command and displays the following error: switch(conf-if-te-0/1)#cee demo switch(conf-if-te-0/1)#qos trust cos % Error: QoS is not in non-CEE Provisioning mode qos cos, show qos 206 Converged Enhanced Ethernet Command Reference 53-1001762-01