HP 8/80 Fabric OS Encryption Administrator's Guide v6.4.0 (53-1001864-01, June - Page 98
Enabling the encryption engine state from Properties, Viewing and editing group properties
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
2 Viewing and editing group properties Enabling the encryption engine state from Properties To enable the encryption engine, complete the following steps. 1. Find the Set State To entry under Encryption Engine Properties. 2. Click the field and select Enabled. 3. Click OK. Disabling the encryption engine state from Properties To disable the encryption engine, complete the following steps. 1. Find the Set State To entry under Encryption Engine Properties. 2. Click the field and select Disabled. 3. Click OK. Viewing and editing group properties To view encryption group properties, complete the following steps. 1. Select Configure > Encryption. The Encryption Center dialog box displays. 2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu bar. The encryption groups display in the Encryption Devices table. 3. Select a group from the Encryption Devices table, and select Group > Properties from the menu bar, or right-click the group and select Properties. The Encryption Group Properties dialog box, shown in Figure 46, has six tabs which are defined in this section: • "General tab" on page 81 • "Members tab" on page 82 • "Security tab" on page 85 • "HA Clusters tab" on page 86 • "Engine Operations tab" on page 86 • "Tape Pools tab" on page 87 NOTE The Link Keys tab appears only if the key vault type is NetApp LKM. 80 Fabric OS Encryption Administrator's Guide 53-1001864-01