HP AD510A HP StorageWorks MSA1500 cs SCSI I/O Module Replacement Instructions - Page 1

Replacement Instructions hp StorageWorks MSA1500 cs SCSI I/O Module These instructions apply to the MSA1500 cs product family. The part may also be used in other HP products. Please refer to documentation for your specific product for detailed replacement instructions. About this document This document details the procedures for replacing a failed MSA1500 cs SCSI I/O module in HP StorageWorks Modular Smart Array (MSA) storage systems. Verifying component failure Before replacing the SCSI I/O module, use the following methods to verify the component failure. ■ Check the controller LCD for one of the error messages listed in Table 1. Table 1: LCD Error Messages No. 23 Message SCSI SUBSYSTEM HARDWARE FAILURE 412 STORAGE BOX # EMU NOT RESPONDING ■ The status LED on the rear of the module is not illuminated or is flashing amber 1. 1 If the product in which this part is being replaced is still under HP warranty, then the replacement part(s) referred to in these Replacement Instructions is provided under the terms and conditions of the Hewlett-Packard Company Limited Warranty for that product. A copy of this Limited Warranty may be viewed at: http://h18006.www1.hp.com/products/storageworks/warranty.html If this is a trade sale part (product out of warranty), then the replacement part(s) referred to in these Replacement Instructions is provided under HP's express limited warranty statement, which may be viewed at: http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/policies/ 2330100.doc The replacement part takes on either the Limited Warranty Period of the part being replaced or a ninety-day period that begins upon installation of the replacement part, whichever is greater. The information contained on these replacement instructions is subject to change without notice. The only warranty for this replacement product is as noted above. Nothing in these replacement instructions should be construed as constituting an additional warranty. The information provided in these replacement instructions is provided "AS IS" and HP is not liable for technical or editorial errors or omissions contained herein. © Copyright 2004 Hewlett-Packard Development Company, L.P. Please note that this document is protected by federal copyright law and that no part of this document may be copied, reproduced or translated without the prior written consent of Hewlett-Packard Development Company, L.P. Printed in Singapore. MSA1500 cs SCSI I/O Module Replacement Instructions First Edition (April 2004) Part Number: 361700-001 361700- 001 Figure 1: Status LED Before you begin Read the following cautions and information before beginning removal and replacement procedures. Caution: Be sure the replacement part is available before removing the failed component. Removing a component impacts cooling within the enclosure. Caution: Parts can be damaged by electrostatic discharge. Use proper anti-static protection. Refer to the documentation that shipped with your system for additional information. Caution: It is important to follow these instructions when replacing components in the MSA. If the procedure is done improperly, it is possible to lose data or damage equipment. Caution: Before replacing this hot-pluggable component ensure that steps have been taken to prevent loss of data.