HP AD510A HP StorageWorks MSA1500 cs SCSI I/O Module Replacement Instructions - Page 2

Step 1: Removing the module Note: Before removing the SCSI I/O module, label all cables. This ensures their reconnection in the correct configuration. 1. Disconnect all SCSI cables from the SCSI I/O module. 2. Lift the port-colored SCSI I/O module latch 1 and pull the SCSI I/O module out of the enclosure 2. Returning the failed component Please follow the return instructions provided in the replacement component package. Additional information For additional information, refer to the MSA technical documents web site at http://www.hp.com/go/msa1500cs. 2 1 Figure 2: Removing the SCSI I/O module Step 2: Installing the module To install a SCSI I/O module: 1. Slide the SCSI I/O module into the bay until it clicks into place. Figure 3: Installing the SCSI I/O module 2. Reconnect all SCSI cables. Note: Make sure that all of the SCSI connectors are fastened tightly. Verifying the replacement After replacing the failed SCSI I/O module, verify that: ■ No error messages are displayed on the controller LCD. ■ The status LED is solid green.Returning the failed component.