HP AJ732A Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April - Page 270
config terminal, interface, no shutdown, Check the attached device and replace it if needed.
UPC - 883585789481
View all HP AJ732A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message PORT-5-IF_BRINGUP_NOT_ALLOWED_PORT_CONFIG_FAILURE: Interface [chars] is not allowed to be operational due to port config failure for reason: [chars] ([hex]). Explanation Check interface configuration. Recommended Action Try to change the configuration on the interface with the current available hardware capability. Introduced Cisco MDS SAN-OS Release 3.0(1). Error Message PORT-5-IF_DOWN_ADMIN_DOWN: Interface [chars] is down (Administratively down). Explanation Interface has been configured to be administratively down. Recommended Action Enter the CLI commands config terminal, interface, no shutdown or use a similar Fabric Manager procedure to bring up the interface. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_BIT_ERR_RT_THRES_EXCEEDED: Interface [chars] is down (Error disabled - bit error rate too high). Explanation The port has detected a bit error rate too high in frames received from attached device. Recommended Action Check the attached device and replace it if needed. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message PORT-5-IF_DOWN_BUNDLE_MISCFG: Interface [chars] is down (Isolation due to channel mis-configuration on local or remote switch). Explanation One port across a link is part of a PortChannel while the other is not. Recommended Action While adding or deleting a member port from a PortChannel, both ports across the link should be added or deleted. No operation should be performed on either port until they are both added or deleted. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_CFG_CHANGE: Interface [chars] is down(Config change). Explanation FCIP interface temporarily down because of reconfiguration. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). 2-234 Cisco MDS 9000 Family System Messages Reference OL-15956-01