HP AP775A Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, Apri - Page 27
LEDs on the Cisco MDS 9200 Series Integrated Supervisor Modules, Status, Description
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Chapter 1 Product Overview Integrated Supervisor Modules LEDs on the Cisco MDS 9200 Series Integrated Supervisor Modules Table 1-1 describes the LEDs for the Cisco MDS 9200 Series integrated supervisor modules. Table 1-1 LEDs for the Cisco MDS 9200 Series Integrated Supervisor Modules LED Status Description Status Green All diagnostics pass. The module is operational (normal initialization sequence). Orange One of the following occurs or occurred: • The module is booting or running diagnostics (normal initialization sequence). • The inlet air temperature of the system exceeded the maximum system operating temperature limit (a minor environmental warning). To ensure maximum product life, you should immediately correct the environmental temperature and restore the system to normal operation. Red One of the following occurred: • The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. Speed1 On • The inlet air temperature of the system exceeded the safe operating temperature limits of the card (a major environmental warning). The card shut down to prevent permanent damage. The system will be shut down after two minutes if this condition is not cleared. 2-Gbps mode. Off 1-Gbps mode. Link Solid green Link is up. Flashing Link is up (beacon used to identify port). green Solid yellow Link is disabled by software. Flashing A fault condition exists. yellow Off No link. 1. The Speed LEDs are available only on Cisco MDS 9216i and Cisco MDS 9216A Supervisor Modules. OL-16188-01 Cisco MDS 9200 Series Hardware Installation Guide 1-9