HP AP775A Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, Apri - Page 42

Services Modules Chapter 1 Product Overview LEDs on the 14/2-Port Multiprotocol Services Module Table 1-7 describes the LEDs for the MPS-14/2 modules. Table 1-7 LEDs for the Cisco MDS 9000 Family MPS-14/2 Modules LED Status Description Status Green All diagnostics pass. The module is operational (normal initialization sequence). Orange One of the following occurs or occurred: • The module is booting or running diagnostics (normal initialization sequence). • The inlet air temperature of the system exceeded the maximum system operating temperature limit (a minor environmental warning). To ensure maximum product life, you should immediately correct the environmental temperature and restore the system to normal operation. Red One of the following occurred: • The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. • The inlet air temperature of the system exceeded the safe operating temperature limits of the card (a major environmental warning). The card shut down to prevent permanent damage. Speed On 2-Gbps mode. Off 1-Gbps mode. Flashing Link is up (beacon used to identify port). green Link Solid green Link is up. Solid Link is disabled by software. yellow Flashing A fault condition exists. yellow Off No link. IP Storage Services Modules The 8-port and 4-port IP Storage services (IPS-8 and IPS-4) modules provide eight or four 1-Gigabit Ethernet ports for iSCSI as well as FCIP over Gigabit Ethernet, and they support the intelligent features available on other modules, including VSANs, security, and traffic management. The IPS module ports support the iSCSI protocol, the FCIP protocol, or both protocols simultaneously. For information about configuring the ports, see the Cisco MDS 9000 Family CLI Configuration Guide and the Cisco MDS 9000 Family Fabric Manager Configuration Guide. 1-24 Cisco MDS 9200 Series Hardware Installation Guide OL-16188-01