HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 651
Con Differentiated Services Code Point DSCP markings., Enable or disable Tape Pipelining.
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 651 highlights
portCfg 2 • portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels. - Configure a tunnel with the FCIP FastWrite feature. - Enable or disable Tape Pipelining. - Configure the compression options. - Configure an IPSec-enabled tunnel (Brocade 7800 only). - Configure VLAN tagging on the default FCIP circuit. - Configure Differentiated Services Code Point (DSCP) markings. - Set the committed rate or minimum and maximum rates for the default circuit. - Configure a tunnel for FICON emulation. • portcfg fcipcircuit - Create, modify, and delete additional FCIP circuits. - Set or modify the committed rate or minimum and maximum rates for the circuit. - Configure or change VLAN tagging on the default circuit. - Set or modify additional circuit parameters. Note In the Fabric OS v6.3.0 and later, you can configure up to 20 FCIP tunnels on the Brocade FX8-24 and up to 8 tunnels on the Brocade 7800. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). ve_port Specifies the number of the VE_Port associated with the tunnel configured on one of the GbE/10GbE ports to be configured. The VE_Ports are numbered 16-23 on the Brocade 7800 and 12-31 on the Brocade FX8-24 blade. fciptunnel Creates, modifies, or deletes a Fibre Channel over IP (FCIP) tunnel. Note the following port mapping restriction on the Brocade FX8-24: The Brocade FX8-24 has two FCIP chips and each one controls specific GbE ports and VE ports. The first FCIP chip controls VE_Ports 12-21, and the GbE ports ge0-ge9 and xge1. The second FCIP chip controls VE_Ports 22-31 and xge0. You can only use IP addresses on ge0-ge9 and xge1 for any FCIP circuits that use VE_Ports 12-21. And likewise, you can only use IP addresses on xge0 for any FCIP circuits that use VE_Ports 22-31. The syntax for portcfg fciptunnel is as follows: portcfg fciptunnel [slot/]ve_port options [tunnel_arguments] [circuit_arguments] The following options are supported with fciptunnel: create [tunnel_arguments] [circuit_arguments] Creates an FCIP tunnel and, optionally a single default circuit. If no circuit arguments are specified, no FCIP circuit will be created. While it is possible to create a tunnel without a default circuit, it is an unlikely scenario (for example, for configuration staging purposes). In most cases, you will create a tunnel with at least one configured FCIP circuit. In this case, you must specify a remote and local IP address for the circuit as well as a committed rate (or alternately, a minimum and maximum committed rate) to configure the Fabric OS Command Reference 619 53-1001764-01