HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 837

portThConfig 2 -timebase time_base Specifies the time interval between two samples to be compared. Valid intervals are: day Samples are compared once a day. hour Samples are compared once every hour. minute Samples are compared once every minute. second Samples are compared once every second. -highthreshold -value value Specifies the high threshold value for triggering a specified alert action. To change the default value, provide an integer value. -lowthreshold -value value Specifies the low threshold for triggering a specified alert action. To change the default value, provide an integer value. -trigger above | below Specifies the actions for in range port behavior. In range is defined as the space above the low threshold and below the high threshold. -action actions Specifies the actions triggered by a configured event condition. Valid values include one or more of the following actions. If more than one action is specified, the actions must be separated by commas. raslog Event triggers a RASlog message. snmp Event triggers an SNMP trap. email Event triggers an e-mail. poortlog Event triggers a port log entry none -buffer value Event triggers no action. Specifies the buffer value for in range behavior. A buffer defines a zone within which event criteria are met, rather than a single threshold value. This operand is valid only with the -trigger options. -nosave Prevents the configuration changes from being saved persistently. This option allows you to make and view changes without overwriting the saved configuration. When you use --set with the -nosave option and the switch reboots your changes will be lost. --apply Applies the custom or default configuration for thresholds, actions, or both. This command allows you to toggle between custom and default settings. The specified configuration takes effect upon execution of this command. When you select custom, the saved configuration becomes effective. You must specify a port type and area when applying a configuration. --cancel Cancels a nonpersistent custom configuration. This command effectively undoes the -nosave operation without reboot. You must specify a port type and area type with this command. Thresholds and alarm levels are optional with this command; if omitted, all nonpersistent configurations for the specified port type and area type are canceled. Fabric OS Command Reference 805 53-1001764-01