HP CB510A HP LaserJet P4010 and P4510 Series - User Guide - Page 46
Table 2-1, Menu item, Sub-menu item, Values and Description
View all HP CB510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Table 2-1 Embedded Jetdirect and EIO Jetdirect menus (continued) Menu item Sub-menu item Sub-menu item Values and Description Select YES to choose this test, or NO to not choose it. DATA PATH TEST This test helps to identify data path and corruption problems on an HP postscript level 3 emulation product. It sends a predefined PS file to the product, However, the test is paperless, so the file does not print. Select YES to choose this test, or NO to not choose it. SELECT ALL TESTS Select this item to run all the embedded tests. Select YES to run all tests, or select NO to not run all tests. EXECUTION TIME [H] Use this item to specify the length of time (in hours) that an embedded test will be run. You can select a value from 1 to 60 hours. If you select zero (0), the test runs indefinitely until an error occurs or the product is turned off. Data gathered from the HTTP, SNMP, and Data Path tests is printed after the tests have completed. EXECUTE NO*: Do not initiate the selected tests. YES: Initiate the selected tests. PING TEST This test is used to check network communications. This test sends link-level packets to a remote network host, then waits for an appropriate response. DEST TYPE Specify whether the target device is an IPv4 or IPv6 node. DEST IPV4 Type the IPv4 address. DEST IPV6 Type the IPv6 address. PACKET SIZE Specify the size of each packet, in bytes, to be sent to the remote host. The minimum is 64 (default) and the maximum is 2048. TIMEOUT Specify the length of time, in seconds, to wait for a response from the remote host. The default is 1 and the maximum is 100. COUNT Specify the number of ping test packets to send for this test. Select a value from 1 to 100. To configure the test to run continuously, select 0. PRINT RESULTS If the ping test was not set for continuous operation, you can choose to print the test results. Select YES to print results. If you select NO (default), results are not printed. EXECUTE Specify whether to initiate the ping test. Select YES to initiate the test, or NO to not run the test. PING RESULTS Use this item to view the ping test status and results using the control panel display. PACKETS SENT Shows the number of packets (0 - 65535) sent to the remote host since the most recent test was initiated or completed. 34 Chapter 2 Control panel ENWW