HP CB510A HP LaserJet P4010 and P4510 Series - User Guide - Page 80
Link speed and duplex settings, CON DEVICE, EMBEDDED JETDIRECT, LINK SPEED
View all HP CB510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Link speed and duplex settings The link speed and communication mode of the print server must match the network. For most situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the product from communicating with other network devices. If you need to make changes, use the product control panel. NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle. 1. Press Menu . 2. Press the down arrow to highlight CONFIGURE DEVICE, and then press OK. 3. Press the down arrow to highlight I/O, and then press OK. 4. Press the down arrow to highlight EMBEDDED JETDIRECT, and then press OK. 5. Press the down arrow to highlight LINK SPEED, and then press OK. 6. Press the down arrow to highlight one of the following options. Setting Auto 10T HALF 10T FULL 100TX HALF 100TX FULL 100TX AUTO 1000TX FULL Description The print server automatically configures itself for the highest link speed and communication mode allowed on the network. 10 megabytes per second (Mbps), half-duplex operation 10 Mbps, full-duplex operation 100 Mbps, half-duplex operation 100 Mbps, full-duplex operation Limits auto-negotiation to a maximum link speed of 100 Mbps 1000 Mbps, full-duplex operation 7. Press OK. The product turns off and then on. 68 Chapter 5 Connectivity ENWW