HP CC395A User Manual - Page 250
Solve common Macintosh problems
View all HP CC395A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
Solve common Macintosh problems This section lists problems that can occur when using Mac OS X. Table 12-1 Problems with Mac OS X The printer driver is not listed in the Print Center or Printer Setup Utility. Cause Solution The printer software might not have been installed or was installed incorrectly. The Postscript Printer Description (PPD) file is corrupt. Make sure that the printer PPD is in the following hard-drive folder: Library/Printers/PPDs/Contents/Resources/ .lproj, where is the two-letter language code for the language that you are using. If necessary, reinstall the software. See the getting started guide for instructions. Delete the PPD file from the following hard-drive folder: Library/ Printers/PPDs/Contents/Resources/.lproj, where is the two-letter language code for the language that you are using. Reinstall the software. See the getting started guide for instructions. The printer name, IP address, or Rendezvous/Bonjour host name does not appear in the printer list in the Print Center or Printer Setup Utility. Cause Solution The printer might not be ready. The wrong connection type might be selected. The wrong printer name, IP address, or Rendezvous/Bonjour host name is being used. Make sure that the cables are connected correctly, the printer is on, and the ready light is on. If you are connecting through a USB or Ethernet hub, try connecting directly to the computer or use a different port. Make sure that USB, IP Printing, or Rendezvous is selected, depending on the type of connection that exists between the printer and the computer. Print a configuration page in order to check the printer name, IP address, or Rendezvous host name. Verify that the name, IP address, or Rendezvous host name on the configuration page matches the printer name, IP address, or Rendezvous host name in the Print Center or Printer Setup Utility. The interface cable might be defective or of poor quality. Replace the interface cable. Make sure to use a high-quality cable. The printer driver does not automatically set up your selected printer in the Print Center or Printer Setup Utility. Cause Solution The printer might not be ready. Make sure that the cables are connected correctly, the printer is on, and the ready light is on. If you are connecting through a USB or Ethernet hub, try connecting directly to the computer or use a different port. The printer software might not have been installed or was installed incorrectly. Make sure that the printer PPD is in the following hard-drive folder: Library/Printers/PPDs/Contents/Resources/ .lproj, where is the two-letter language code for the language that you are using. If necessary, reinstall the software. See the getting started guide for instructions. 236 Chapter 12 Problem solve ENWW