HP Cisco MDS 9134 Cisco MDS 9000 Family CLI Configuration Guide, Release 3.x ( - Page 500

Configuring SDV Chapter 20 SAN Device Virtualization Send documentation comments to [email protected] Configuring a Zone for a Virtual Device After configuring a virtual device, you must create a zone that includes all the other real devices and the virtual device as members, and add this zone to a zone set, which you can activate. You can add the virtual device to the zone using the configured name and member type as the device alias. Note This configuration process does not support interoperability. If you are working in interop-VSANs, we recommend that you configure the zone directly using the system-assigned pWWN of the virtual device. Figure 20-6 shows a virtual device-name device alias (vt1) zoned with the real devices activated; the primary device is online. Figure 20-6 Zoning the Virtual Device with Real Devices SAN Device Virtualization vtpwwn vt1 SAN Device Virtualization Zone i1pwwn i2pwwn i3pwwn i1 i2 i3 Virtual Device t1pwwn t1 t2pwwn t2 159901 Primary Secondary To add the virtual device to a zone as a zone member, follow these steps: Step 1 Step 2 switch# config t switch(config)# zoneset name zs1 vsan 1 Step 3 Step 4 Step 5 Step 6 switch(config-zoneset)# zone name zone1 switch(config-zoneset-zone)# member device-alias vdev1 or switch (config-zoneset-zone)# member pwwn 50:00:53:00:01:fa:70:09 switch(config-zoneset-zone)# member pwwn 21:22:5:d8:15:11:8:8 switch(config-zoneset-zone)# end Enters configuration mode. Groups zones under one zone set named zs1 in the VSAN, vsan 1. Enters zone set submode. Creates the zone zone1. Adds a virtual device (vdev1) as device-alias type zone member to the zone. Alternatively, adds a virtual device as pWWN type zone member to the zone. Adds the real device to the zone. Exits all modes. 20-6 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x