HP Cisco MDS 9140 HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE - Page 14
C-Series IP Storage Services Modules (IPS-4, IPS-8)
View all HP Cisco MDS 9140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2) and MDS 9216i configuration constraints C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2) and MDS 9216i constraints Table 1 C-Series iSCSI limits iSCSI component iSCSI host connections per port Active LUNs per port Number of Initiator/Targets (IT) Nexus per port Number of active LUNs per IT Nexus Number of IT Nexus/LUNs combinations per port Maximum 200 200 200 256 1200 Examples of maximum configurations for IT Nexus: • 200 iSCSI initiators each connected to one target (storage controller port) • 100 iSCSI initiators each connected to two targets • 50 iSCSI initiators each connected to two targets and 100 iSCSI initiators each connected to one target iSCSI host constraints Table 2 iSCSI host limits for Windows 2003 iSCSI host component Targets accessed per host LUNs per target Maximum 8 255 Fibre Channel switch and fabric constraints The C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), and MDS 9216i switch are supported on any currently supported HP Infrastructure C-Series switch fabric. For the latest HP Infrastructure switch topologies and fabric rules, refer to the HP StorageWorks SAN design reference guide, which can be downloaded from the following web site: http://h18000.www1.hp.com/products/storageworks/san/documentation.html Configuring SANs with C-Series switches and iSCSI in a Windows environment To configure the C-Series IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2) and MDS 9216i switch in an HP Fibre Channel SAN: 1. Enable iSCSI on the C-Series switch 2. Present iSCSI hosts as virtual FC hosts 3. Install the Microsoft iSCSI initiator 14