HP Cisco MDS 9216 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 604

install clock-module Chapter 11 I Commands Send documentation comments to [email protected] install clock-module To upgrade the EPLD images of the clock module on a Cisco MDS 9513 Switch Director, use the install clock-module command. install clock-module [epld {bootflash: | slot0: | volatile:}] Syntax Description epld bootflash: slot0: volatile: Installs the clock module EPLD from the EPLD Image. Local URI containing EPLD Image. Local URI containing EPLD Image. Local URI containing EPLD Image. Defaults None. Command Modes EXEC mode. Command History Release 3.0(1) Modification This command was introduced. Usage Guidelines Use this command on the active supervisor to install the standby clock module EPLD from the specified EPLD image. After upgrading the clock module, power cycle the entire chassis for the change to take effect. It is not sufficient to reboot the chassis; you must turn the power off and on. Note This command is supported only on the Cisco MDS 9513 Multilayer Switch Director. Examples The following example upgrades the EPLD images for the clock module. switch# install clock-module epld bootflash:m9000-epld-3.0.0.278.img Len 3031343, CS 0x58, string MDS series EPLD image, built on Fri Nov 11 01:11:09 2005 EPLD Curr Ver New Ver Clock Controller 0x03 0x04 There are some newer versions of EPLDs in the image! Do you want to continue (y/n) ? y Proceeding to program Clock Module B. Do you want to switchover Clock Modules after programming Clock Module B. System Will Reset! y/n) ?n | Clock Module B EPLD upgrade is successful. 11-12 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x