HP Cisco MDS 9216 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Rel - Page 32
Virtual Targets CVTs or SANTap Data Virtual Targets DVTs so that the running configuration
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Caveats Send documentation comments to [email protected] • CSCsk35725 Symptom: Fabric Manager takes 2 to 3 minutes to bring up the DMM job creation wizard in a setup with 25 switches, 400 enclosures, and 2400 entries in the name server. Workaround: None. • CSCso49196 Symptom: During an upgrade from SAN-OS Release 3.2(3a) to Release 3.3(1a), when a switchover occurs to the Supervisor running Release 3.3(1a), Cisco SME traffic flows for hosts that are not connected locally to the switch that is getting upgraded, may get flapped for a very short time. This can also occur during a switchover to a Supervisor running Release 3.3(1a). Workaround: None. • CSCsq20408 Symptom: After creating SANTap Control Virtual Targets (CVTs) or SANTap Data Virtual Targets (DVTs), the running-configuration and the startup-configuration are not synchronized. Output from the show startup-config command will be different from the output of the show running-config and the startup configuration will not display SANTap configuration information. Workaround: Issue the copy running-startup command whenever you create SANTap Control Virtual Targets (CVTs) or SANTap Data Virtual Targets (DVTs) so that the running configuration and the startup configuration are synchronized. • CSCta55819 Symptom: Cisco Fabric Services (CFS) callhome commands are not working in NPV mode, even though CFS is working in NPV mode. Workaround: None. • CSCtc86203 Symptom: When the customer enters the install all ssi command to upgrade the SSI image on the SSM module, the ilc_helper command will not run on the standby module because of the install all command. This situation affects SSI functionality if the device switches over to the standby module. Workaround: Always enter the install ssi module command to upgrade the SSI image on a module. Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(4a) 32 OL-14116-13