HP Cisco MDS 9216A Cisco MDS 9100 Series Hardware Installation Guide (OL-17951 - Page 35
Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series, Step 3
View all HP Cisco MDS 9216A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 2 Installing the Cisco MDS 9100 Series Installing the Switch in a Cabinet or Rack Send documentation comments to [email protected] Figure 2-1 Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series 2 96616 1 Front rack-mount bracket 1 2 C bracket Step 3 Install the slider rails in the rack. Position one of the slider rails against the rack mounting rails and align the screw holes as shown in Figure 2-2. If you are using the notched slider rails for the Cisco MDS 9134 or the Cisco MDS 9124 Switch, see Figure 2-3. Note Depending on when you purchased your Cisco MDS 9124 Switch, you may have straight slider rails like those shown in Figure 2-2, or you may have the notched slider rails like those shown in Figure 2-3. Refer to the illustrations that show the type of rails that came with your switch. Step 4 Attach the slider rail using two 12-24 screws or two 10-32 screws, depending on the rack rail thread type. For racks with square holes, insert the 12-24 cage nuts in position behind the mounting holes in the slider rails. a. Repeat with the other slider rail on the other side of the rack. OL-17951-02 Cisco MDS 9100 Series Hardware Installation Guide 2-7