HP Cisco MDS 9216i Cisco MDS 9000 Family Fabric Manager Configuration Guide - - Page 404

Identifying Module LEDs Chapter 19 Managing Modules Send documentation comments to [email protected] Table 19-6 describes the LEDs for the Cisco MDS 9200 Series interface module. Table 19-6 LEDs on the Cisco MDS 9200 Series Interface Module LED Status Description Status Green All diagnostics pass. The module is operational (normal initialization sequence). Orange One of the following applies: The module is booting or running diagnostics (normal initialization sequence). The inlet air temperature of the system has exceeded the maximum system operating temperature limit (a minor environmental warning). To ensure maximum product life, you should immediately correct the environmental temperature and restore the system to normal operation. Red One of the following applies: The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. The inlet air temperature of the system has exceeded the safe operating temperature limits of the card (a major environmental warning). The card has been shut down to prevent permanent damage. System Green All chassis environmental monitors are reporting OK. Orange One of the following applies: The power supply failed or the power supply fan failed. Incompatible power supplies are installed. The redundant clock failed. Red The temperature of the supervisor module exceeded the major threshold. MGMT 10/100 Green Ethernet Link Off LED Link is up. No link. MGMT 10/100 Green Ethernet Off Activity LED Traffic is flowing through port. No link or no traffic. Table 19-7 describes the LEDs for the 16-port and 32-port switching modules, and the 4-port, 12-port, 24-port, and 48-port Generation 2 switching modules. 19-10 Cisco MDS 9000 Family Fabric Manager Configuration Guide OL-17256-03, Cisco MDS NX-OS Release 4.x