HP Cisco Nexus 5000 Cisco Nexus 5000 Series Release Notes Release 4.0(1a)N1(1a - Page 14

Caveats Send documentation comments to [email protected] • CSCsv00989 Symptom: The command show interface ethernet transceiver details may show all zero values for DOM-capable 1 G SFP. Workaround: None. • CSCsu48008 Symptom: When a Virtual Fibre Channel (VFC) interface is down, the fcIfOperStatusCause MIB object does not report the correct reason. Workaround: Get the OperStatus from the CLI using the show interface vfc x command. • CSCsu77946 Symptom: Within a configuration session, when you enable statistics on the PACL add more than 252 ACES to the ACL, and apply it to an interface, an error message is generated as the statistics counter is exhausted. Even if you try to remove the statistics keyword, it does not get removed. The result is that the ACL cannot be applied to the interface. This problem occurs only with a configuration session, and only after a configuration failure. Workaround: Reduce the size of the ACL (fewer than 252 ACES) and re-apply the ACL to an interface. The statistics keyword will still remain and consume hardware resources. • CSCsu93313 Symptom: Within a configuration session, 125 unique VACLs are created with a total of 1023 TCAM entries. The verify command fails with the following message: d2-switch-2(config)# configure session 30 Config Session started, Session ID is 1 d2-switch-2(config-s)# verify Failed to start Verification: Message Timed Out d2-switch-2(config-s)# commit Failed to complete Verification: no free label This problem occurs with large VACL configurations. Once the Cisco Nexus 5000 Series switch gets into this state, subsequent VACL configurations fail. Workaround: A reload is needed to recover the configuration. • CSCsu50589 Symptom: If an invalid IP address is configured within a RADIUS configuration (such RADIUS server), any manipulation of the RADIUS configuration causes timeouts to the console such as show running-configuration or copy running to startup. Workaround: Configure a valid IP address for a RADIUS configuration. • CSCsv19979 Symptom: Any FC port set to SD mode does not come up until the speed is configured manually. The port goes into the Error disabled state and the only way to bring it online as SD is to manually set the speed 2 G or 4 G. Workaround: Configure the speed manually to 2 G or 4 G. • CSCsv00402 Symptom: When you downgrade from the 4.0(1a)N1 release to a previous software release, any static IGMP entries that have been configured over an Ether channel are lost after the downgrade. Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1a) 14 OL-16601-01