HP D5064S User Guide - HP L156v 15" and L176v 17" LCD Monitors - Page 12

Setting Up the Monitor Power Cord Be sure the power cord is the correct type required in your region. This LCD monitor has an internal universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.) ✎ A certified power supply cord has to be used with this equipment. The relevant national installation and/or equipment regulations shall be considered. A certified power supply cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227 (designation H05VV-F 3G 0.75mm2 or H05VVH2-F2 3G 0.75mm2) shall be used. Alternative: a flexible cord of synthetic rubber according to IEC 60245 (designation H05RR-F 3G 0.75mm2) shall be used. Connecting the Monitor 1. Connecting the signal cable: Connect one end of the signal cable into the LCD monitor's socket, the other end into the computer's VGA port, and tighten the two screws on the cable connector. 2. Connecting the power cord: Connect one end of the AC-power cord into the LCD monitor's AC input socket, the other end into the wall outlet. Ä CAUTION: If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied). 3. Connecting the audio line: Connect one end of an audio cable into the computer's multimedia (or sound) card's audio output, and the other end into the monitor's audio input. 3-2 User Guide