HP Engage Go 10 User Guide - Page 21

Attaching an I/O connectivity base to the mobile system

Get HP Engage Go 10 PDF manuals and user guides View all HP Engage Go 10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

▲ Press the lock release button (1) on the front of the dock's column, and then lift the mobility head unit (2) off the dock. Attaching an I/O connectivity base to the mobile system You can attach an I/O connectivity base to the bottom of the stand. To attach an I/O connectivity base: 1. Turn off the mobility system properly through the operating system, and turn off any external devices. 2. Disconnect the power cords from the mobility system and I/O connectivity base. IMPORTANT: Regardless of the power state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord and wait approximately 30 seconds for the power to drain to avoid damage to the internal components. 3. Remove the cover from the I/O connectivity base by removing the four screws on the underside of the I/O connectivity base (1) and then lifting the cover off the I/O connectivity base (2). Attaching an I/O connectivity base to the mobile system 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
▲
Press the lock release button
(1)
on the front of the dock’s column, and then lift the mobility head unit
(2)
off the dock.
Attaching an I/O connectivity base to the mobile system
You can attach an I/O connectivity base to the bottom of the stand.
To attach an I/O connectivity base:
1.
Turn off the mobility system properly through the operating system, and turn off any external devices.
2.
Disconnect the power cords from the mobility system and I/O connectivity base.
IMPORTANT:
Regardless of the power state, voltage is always present on the system board as long as
the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components.
3.
Remove the cover from the I/O connectivity base by removing the four screws on the underside of the I/O
connectivity base
(1)
and then lifting the cover off the I/O connectivity base
(2)
.
Attaching an I/O connectivity base to the mobile system
15