HP Engage Go 10 User Guide - Page 22
the USB Type-C power cable is routed through the gap between the back of the I/O connectivity base
View all HP Engage Go 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
4. Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand column. 5. Place the I/O connectivity base onto the bottom of the stand (1), and then tighten the four screws on the underside of the I/O connectivity base (2) to secure the I/O connectivity base to the dock. Be sure that the USB Type-C power cable is routed through the gap between the back of the I/O connectivity base and the stand. 16 Chapter 3 Hardware setup
4.
Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand column.
5.
Place the I/O connectivity base onto the bottom of the stand
(1)
, and then tighten the four screws on the
underside of the I/O connectivity base
(2)
to secure the I/O connectivity base to the dock. Be sure that
the USB Type-C power cable is routed through the gap between the back of the I/O connectivity base and
the stand.
16
Chapter 3
Hardware setup