HP Envy 13-1003xx HP ENVY 13 - Maintenance and Service Guide - Page 50
built into the system board., Remove the wireless antenna cables from the rubber clips
View all HP Envy 13-1003xx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Removal and replacement procedures Remove the system board: 1. Remove the Phillips PM1.5×3.0 screw 1 that secures the power connector bracket to the base enclosure. 2. Remove the power connector bracket 2. 3. Release the power connector 3 from the clip built into the base enclosure. 4. Disconnect the display panel cable 4 from the system board. 5. Remove the wireless antenna cables from the rubber clips 5 built into the system board. 6. Remove the five Phillips PM2.0×4.0 screws 1 and the two Phillips PM2.0×6.0 screws 2 that secure the system board to the base enclosure. Maintenance and Service Guide 4-21
Removal and replacement procedures
Maintenance and Service Guide
4–21
Remove the system board:
1. Remove the Phillips PM1.5×3.0 screw
1
that secures the power connector bracket to the base enclosure.
2. Remove the power connector bracket
2
.
3. Release the power connector
3
from the clip built into the base enclosure.
4. Disconnect the display panel cable
4
from the system board.
5. Remove the wireless antenna cables from the rubber clips
5
built into the system board.
6.
Remove the five Phillips PM2.0×4.0 screws
1
and the two Phillips PM2.0×6.0 screws
2
that secure the system
board to the base enclosure.