HP Envy 13-1030nr HP ENVY 13 - Maintenance and Service Guide - Page 57
that services it., and the fan/heat sink assembly
View all HP Envy 13-1030nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Removal and replacement procedures 3. Disconnect the fan cable 1. 4. Following the 1, 2, 3, 4, 5, 6 sequence stamped into the fan/heat sink assembly, remove the six Phillips PM1.5×3.0 screws 2 that secure the fan/heat sink assembly to the system board. 5. Remove the fan/heat sink assembly 3. ✎ Due to the adhesive quality of the thermal material located between the fan/heat sink assembly and system board components, it may be necessary to move the fan/heat sink assembly from side to side to detach it. ✎ The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink assembly and the system board each time the fan/heat sink assembly is removed: ■ Thermal paste is used on the processor 1 and the fan/heat sink assembly section 2 that services it. ■ Thermal pads are used on the Northbridge chip 3 and the fan/heat sink assembly section 4 that services it. ■ Thermal pads are used on the video chip 5 and the fan/heat sink assembly section 6 that services it. Replacement thermal material is included with all system board and fan/heat sink assembly spare part kits. Reverse this procedure to install the fan/heat sink assembly. 4-28 Maintenance and Service Guide