HP G62-415NR Service Guide - Page 93
and the processor
View all HP G62-415NR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
2. Disconnect the fan cable from the system board. 3. Loosen the three Phillips captive screws (1) and three Phillips spring-loaded captive screws (2) that secure the fan/heat sink assembly. NOTE: Due to the adhesive quality of the thermal material located between the fan/heat sink assembly and system board components, it might be necessary to move the fan/heat sink assembly from side to side to detach the assembly. 4. Remove the fan/heat sink assembly (3) by lifting straight up. Reverse this procedure to install the fan/heat sink assembly. The thermal material must be thoroughly cleaned from the surface of the fan/heat sink assembly (1), (3) and the processor (2) and video components (4) each time the fan/heat sink assembly is removed. Thermal pads and thermal paste must be installed on all surfaces before the fan/heat sink assembly is reinstalled. ENWW Component replacement procedures 83