HP HP-380467-003 Upgrading and Servicing Guide

HP HP-380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER Manual

HP HP-380467-003 manual content summary:

  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 1
    Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 2
    be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by uses only. Other brand or product names are trademarks of their respective holders. HP supports lawful use of technology and does not endorse or encourage the use of
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 3
    Hard Disk Drive 12 Removing a Second Hard Disk Drive 15 Adding Memory 16 Removing a Memory Module 16 Installing a Memory Module 16 Removing or Installing an Add-in Card 17 Removing an Add-in Card 17 Installing an Add-in Card 18 Replacing the Battery 18 Upgrading and Servicing Guide iii
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 4
    iv Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 5
    power system. The Upgrading and Servicing Guide provides instructions on how to remove and replace hardware components of your PC. Opening and Closing the PC Preparing the PC Before you upgrade any component in your PC, you need to prepare the PC up and examine the PC. • HP recommends that you use
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 6
    touching. 4 Disconnect the power cord from the electrical outlet and then from the PC. 5 Disconnect all other card, install any software drivers supplied by the card manufacturer. Removing the Side Panel 1 See "Before Opening the PC" on page 1. 2 PC" on page 2. 2 Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 7
    Removing the Front Panel This procedure is necessary only when removing or replacing an optical drive, a memory card reader, or a diskette drive. 1 Remove the side panel. See "Removing the Side Panel" on page 2. 2 Unlock to lock when the tab is in the lock position. Upgrading and Servicing Guide 3
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 8
    with the Microsoft ® Windows® XP operating system. Also, make sure you have the correct software and drivers for the optical drive to work with the operating system. You can replace the (primary) hard disk drive or install a second hard disk drive in the PC. E F 4 Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 9
    drive all the way in through the front of the PC until it snaps into place (D). 7 Replace the front panel. See "Replacing the Front Panel" on page 3. 8 Complete the procedures to replace the side panel, and to close the PC. See "Opening and Closing the PC" on page 1. Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 10
    , follow the second set of instructions, "To remove a drive (with a removable drive cage) (select models)" on page 6. To ensure that the drive fits properly into the PC, be sure to purchase the replacement diskette drive from HP. Refer to the Warranty and Support Guide for contact information. To
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 11
    Card Reader or a Diskette (Floppy) Drive The PC may have a fixed or a removable drive cage that holds the memory card reader and the diskette drive. If the drive cage is fixed, follow the first set of instructions, "To install a drive (with a fixed drive cage) (select models)" on page 7. If the
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 12
    first set of instructions, "To remove a hard disk drive (with a hard disk drive cage)" on page 9. If your hard disk drive is not located inside a cage, follow the second set of instructions, "To remove a hard disk drive (without a hard disk drive cage)" on page 10. 8 Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 13
    cable 5 Push the release tab attached to the hard disk drive bracket (H) until it is unlocked. Gently push the hard disk drive in the same direction and then pull it out of the hard disk drive bracket (J). H 1 Disconnecting the Serial ATA hard disk drive cables J Upgrading and Servicing Guide 9
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 14
    drive connector. For Parallel ATA hard disk drive cables, use a gentle rocking motion to free the plugs. 2 1 5 Make a note of each cable attached to the hard disk drive before removing the cables. Disconnecting the Serial ATA hard disk drive cables MASTER To CPU 10 Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 15
    locate the hard disk drives and data may be lost. L 4 Push the release tab on the top of the hard disk drive bracket into the locked position (L). 5 Complete the procedures to replace the side panel, and to close the PC. See "Opening and Closing the PC" on page 1. Upgrading and Servicing Guide 11
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 16
    you want to install a second hard disk drive, please contact Customer-replaceable Parts Service, which is available in some countries/regions. For contact information, refer to the Warranty and Support Guide. If your PC does include a cage around the hard disk drive, use the following instructions.
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 17
    the chassis (O). 7 Connect the power and data cables to the back of the second hard disk drive. For a Parallel ATA hard disk drive, connect the data IDE cable end labeled Slave to the drive. MASTER SLAVE To CPU Connecting the Parallel ATA hard disk drive data cable Upgrading and Servicing Guide 13
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 18
    the data IDE cable labeled To CPU to the motherboard connector Primary. 13 Replace the front panel. See "Replacing the Front Panel" on page 3. 14 Complete the procedures to replace the side panel, and to close the PC. See "Opening and Closing the PC" on page 1. 14 Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 19
    chassis to release the second hard disk drive from the front of the chassis (P). Lift the second hard disk drive out of the chassis. Disconnecting the Serial ATA hard disk drive cables MASTER SLAVE To CPU Disconnecting the Parallel ATA hard disk drive data cable Upgrading and Servicing Guide 15
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 20
    memory module your PC uses, and for specific memory module information and specifications, go to the Web site listed in your Warranty and Support Guide and click the Support PC" on page 1. 2 Gently lay the PC on its side. 3 Locate the memory sockets on the motherboard. CAUTION: When handling a memory
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 21
    tab on the memory socket. Push (average) of +5 V power for each board/card in the PC. The total +5 V current PC and remove the side panel. See "Opening and Closing the PC" on page 1. 2 Gently lay the PC on its side. 3 Inside the PC, locate the add-in card slots on the motherboard Servicing Guide 17
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 22
    close the PC. See "Opening and Closing the PC" on page 1. NOTE: If the new card or device isn't working, read through the card manufacturer's installation instructions, and recheck all connections, including those to the card, power supply, keyboard, and monitor. 18 Upgrading and Servicing Guide
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 23
  • HP HP-380467-003 | Upgrading and Servicing Guide - Page 24
    Printed in
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Upgrading and Servicing Guide